Cable Management on Site

• Plan cable routes before starting work to avoid crossing walkways.
• Use cable ramps or bridges where cables must cross pedestrian routes.
• Route cables overhead on cable hangers where practical.
• Inspect cables daily for damage to outer sheaths and connectors.
• Coil and store unused cables off the ground when not in use.
• Position distribution boards close to the work area to reduce runs.
• Use 110V supply with RCD protection for all portable equipment.
• Secure cables to walls or structures using proper clips and ties.
• Report damaged cables immediately and remove them from service.
• Include cable management in your pre-task briefing and risk assessment.

• DON'T run cables across walkways without protection or overhead routing.
• DON'T drag cables over sharp edges, through doorways, or under loads.
• DON'T use damaged cables even if the inner core looks undamaged.
• DON'T daisy-chain extension leads together to extend cable runs.
• DON'T cover cables with materials that hide them as a trip hazard.
• DON'T allow plant or vehicles to drive over unprotected cables.
• DON'T leave coiled cables in walkways, stairwells, or access routes.
• DON'T use cable ties as a permanent fix for damaged sheathing.
• DON'T ignore cables from other trades — report and manage them too.
• DON'T assume someone else will sort out poor cable management.

See also: Slips, Trips and Falls Awareness | Good Housekeeping Standards