Temporary boarding and walkways provide safe pedestrian access across excavations, between buildings, and over rough ground on construction sites. Poorly maintained or inadequately constructed walkways are a major cause of slips, trips, and falls. This talk covers the standards required for temporary walkways and boarding to keep pedestrians safe on UK construction sites.
Key Hazards
Falls through gaps or holes in incomplete or damaged temporary boarding
Trips on raised edges, loose boards, and uneven walkway surfaces
Slips on wet, muddy, or frost-covered temporary walkway surfaces
Pedestrians falling from elevated walkways without adequate edge protection
Control Measures
Construct temporary walkways at least 600mm wide with a firm, level, non-slip surface.
Secure all boards to prevent movement, rocking, or displacement when walked on.
Install handrails on both sides of any walkway more than one metre above ground level.
Apply non-slip strips or mesh to boarding surfaces that may become wet or contaminated.
Inspect all temporary walkways daily and after heavy rain, frost, or site traffic damage.
Provide adequate lighting along walkway routes including battery backup for night shifts.
Remove debris, mud, and standing water from walkway surfaces before each shift starts.
Mark or barrier any section of walkway that is under construction or awaiting repair.
Brief all site users on the designated pedestrian routes and walkway locations.
Remember
Walkways must be at least 600mm wide with a firm, level, non-slip surface
Secure all boards to prevent movement and apply non-slip treatment to wet surfaces
Install handrails on both sides of any walkway more than one metre above ground
Inspect walkways daily and clear debris, mud, and standing water before each shift
Barrier any section under construction or repair to prevent use until completed
Applicable Legislation: Workplace (Health, Safety and Welfare) Regulations 1992 · CDM 2015 · Work at Height Regulations 2005 · MHSWR 1999