CON/General/TBT-CON-022

Reinforcement Fixing Safety

Concrete & Formwork › General › Reinforcement Fixing Safety

Presenter		Project
Location		Date

Reinforcement fixing involves cutting, bending, and tying steel rebar into cages and mats for concrete structures.
Rebar impalement from exposed vertical starter bars is one of the most serious hazards on concrete frames.
Manual handling of heavy rebar bundles and prefabricated cages causes back injuries and hand crushing.
Wire tying tools and manual tying pliers cause repetitive strain injuries to hands and wrists.
Cutting rebar with hydraulic croppers, disc cutters, and oxy-fuel creates noise, sparks, and vibration hazards.
Working at height on formwork and scaffolding while fixing rebar adds fall risk to the manual task.
Steel fixers suffer high rates of hand lacerations from sharp-cut rebar ends and binding wire.
Prefabricated cages lifted by crane require LOLER-compliant lift plans with exclusion zones.
The CDM Regulations 2015 require rebar impalement protection on all exposed vertical starter bars.
Weather exposure is significant as steel fixers work outdoors in all conditions on open structures.

Prevent impalement	Falling onto exposed vertical rebar causes fatal impalement injuries — protection caps are mandatory on all starters.
Manual handling injuries	Rebar is heavy and awkward — chronic back, shoulder, and hand injuries are common without mechanical aids.
Laceration risk	Sharp-cut rebar ends and binding wire cause deep hand cuts that can sever tendons without proper gloves.

Don't

Cap all exposed vertical starter bars with mushroom-type impalement protection immediately
Wear cut-resistant gloves when handling rebar and tying binding wire at all times
Use mechanical aids for lifting and positioning heavy rebar bundles and prefabricated cages
Prepare a lift plan for crane-lifting prefabricated rebar cages with proper exclusion zones
Wear hearing protection when cutting rebar with hydraulic croppers or disc cutters
Rotate tasks between heavy fixing and lighter work to reduce repetitive strain on hands
Ensure fall protection is in place when fixing rebar at height on formwork or scaffolding
Inspect cutting tools and tying equipment before each use and report any defects
Store rebar bundles securely on level ground with chocks to prevent rolling and collapse
Use water suppression when cutting rebar with disc cutters to control metal dust and sparks

DON'T leave exposed vertical starter bars uncapped — impalement protection is mandatory
DON'T handle rebar without cut-resistant gloves — sharp ends cause serious lacerations
DON'T manually lift heavy rebar bundles alone — use mechanical aids or team lifting
DON'T stand beneath prefabricated rebar cages during crane lifting and placement
DON'T cut rebar with disc cutters without hearing protection and spark containment
DON'T fix rebar at height without fall protection secured to an independent anchor
DON'T store rebar bundles on edge or unsecured where they could roll or topple
DON'T ignore wrist or hand pain from repetitive tying — report symptoms early
DON'T use damaged cutting tools with worn blades or hydraulic leaks on site
DON'T work below others fixing rebar overhead without head protection and exclusion zones

See also: Rebar Impalement Prevention | Steel Fixer Safety

Generate professional Risk Assessment and Method Statements in minutes. 10 document formats, site-specific content, instant Word download.

Toolbox Talk Record