PIP/General/TBT-PIP-001

Pipeline Safety Awareness

Pipelines & Pipework › General › Pipeline Safety Awareness

Presenter		Project
Location		Date

Pipeline construction involves trenching, pipe laying, jointing, testing, and commissioning of buried pipe systems.
Pipe materials include ductile iron, HDPE, steel, concrete, and GRP — each has specific handling and jointing procedures.
Trench collapse is a primary hazard during pipeline work — all trenches must be properly supported or battered back.
Pipe jointing methods including butt fusion, electrofusion, flanging, and push-fit require trained, competent operatives.
Pressure testing of completed pipelines involves stored energy that can cause violent pipe failures if not controlled.
Pipeline work often takes place in highways, requiring traffic management and NRSWA competent operatives.
Pipe sections are heavy and awkward — mechanical lifting and handling is required to prevent musculoskeletal injuries.
Existing live services run parallel to and cross pipeline routes — CAT scanning and service plans are mandatory.
Directional drilling and thrust boring are specialist operations used for crossing roads and railways without open cut.
Pipeline commissioning including chlorination, flushing, and purging involves chemicals and pressurised systems.

Prevent trench burial	Pipeline trenches are deep and often narrow — proper support prevents the fatal collapses that occur during pipe laying work.
Pressure testing danger	Stored energy in pressurised pipelines can cause explosive failures — controlled test procedures and exclusion zones save lives.
Service strike risk	Pipeline routes cross existing buried services — undetected cables and gas mains cause electrocution and explosions.

Don't

Ensure trench support or battering is in place before entering any pipeline trench.
Use mechanical lifting for handling pipe sections — do not lift pipes manually when plant is available.
Scan for buried services and review service plans before excavating any pipeline route.
Ensure pipe jointing operatives hold valid competency cards for the jointing method used.
Follow the approved pressure test procedure with exclusion zones before testing begins.
Install traffic management and hold NRSWA cards when carrying out pipeline work in highways.
Use safe pipe lowering methods — never stand in the trench while pipes are being lowered.
Follow COSHH procedures for handling chlorination chemicals during commissioning.
Maintain safe access and egress from pipeline trenches with ladders at regular intervals.
Brief all workers on the pipeline construction sequence and daily hazards each morning.

DON'T enter an unsupported pipeline trench — ensure shoring is in place before entry.
DON'T manually handle heavy pipe sections when mechanical lifting equipment is available.
DON'T dig pipeline trenches without scanning for existing buried services first.
DON'T carry out pipe jointing without valid training and competency for the method.
DON'T stand near pipework during pressure testing — stay outside the exclusion zone.
DON'T work on pipeline routes in highways without traffic management and NRSWA cards.
DON'T stand in the trench while pipe sections are being lowered by the excavator.
DON'T handle chlorine or commissioning chemicals without the correct PPE and COSHH controls.
DON'T work in pipeline trenches without safe ladder access within easy reach.
DON'T skip the daily briefing — pipeline hazards change as the route progresses each day.

See also: HDPE & PE Pipe Butt Fusion | Hydrostatic Pressure Testing

Generate professional Risk Assessment and Method Statements in minutes. 10 document formats, site-specific content, instant Word download.

Toolbox Talk Record