STE/Specific/TBT-STE-016

Portal Frame Erection

Steel Erection › Specific › Portal Frame Erection

Presenter		Project
Location		Date

Portal frames are the most common structural system for industrial buildings, warehouses, and retail units in the UK.
Erection involves lifting columns, rafters, and apex connections using mobile cranes with planned lift sequences.
Portal frames are inherently unstable until purlins, bracing, and cladding rails provide lateral restraint.
Temporary bracing must be installed immediately after each frame is erected to prevent lateral collapse.
The erection sequence must follow the approved method statement to maintain structural stability throughout.
Workers fixing purlins, bracing, and cladding rails work at significant heights on the partially erected frame.
Wind loading on partially clad portal frames creates asymmetric forces that can cause frame buckling.
Connection bolts must be tightened to the specified torque — under-tightened connections lead to structural failure.
BS 5950 and BS EN 1993 (Eurocode 3) set the UK design and erection standards for steel portal frames.
The steel erection contractor must provide a detailed erection method statement and sequence drawing.

Prevent collapse	Portal frames without temporary bracing collapse laterally under their own weight or wind loading.
Fall from height	Working on partially erected frames at height without edge protection is a leading cause of steelwork fatalities.
Erection sequence	Installing frames out of sequence creates instability that puts everyone in the exclusion zone at risk.

Don't

Follow the approved erection sequence exactly as specified in the method statement
Install temporary bracing to each frame immediately after it is crane-lifted into position
Tighten all connection bolts to the specified torque using calibrated torque wrenches
Establish exclusion zones beneath all crane operations during portal frame erection
Ensure fall protection is in place for workers fixing purlins and bracing at height
Monitor wind speed and stop erection when conditions exceed the method statement limits
Use tag lines on all portal frame sections to control swing during crane placement
Brief the full team on the erection sequence, exclusion zones, and rescue plan daily
Inspect temporary bracing connections at the end of each shift for security and condition
Confirm holding-down bolt alignment and grout condition before placing each column

DON'T erect portal frames out of the approved sequence without engineer authorisation
DON'T leave erected frames without temporary bracing — lateral collapse can occur instantly
DON'T under-tighten connection bolts — torque them to specification before loading the frame
DON'T stand beneath portal frame sections being lifted and positioned by the crane
DON'T work at height on the frame without a harness connected to an approved anchor
DON'T remove temporary bracing until permanent purlins and cladding rails are installed
DON'T erect frames in high winds — partially braced structures are vulnerable to wind loading
DON'T assume the frame is stable because it looks secure — check bracing and connections
DON'T store materials or cladding on the frame before it has full permanent restraint
DON'T allow untrained personnel to direct crane lifts during portal frame erection

See also: Steel Erection Safety | Temporary Bracing and Stability

Generate professional Risk Assessment and Method Statements in minutes. 10 document formats, site-specific content, instant Word download.

Toolbox Talk Record