TRD/Civils/TBT-TRD-007

Steel Fixer Safety

Trade-Specific Safety › Civils › Steel Fixer Safety

Presenter		Project
Location		Date

Steel fixers cut, bend, and tie reinforcement bars (rebar) to form the steel skeleton inside concrete structures.
The role involves constant manual handling of heavy steel bars weighing 10-40 kg each depending on diameter.
Rebar impalement is a serious hazard — unprotected vertical bars have caused fatal injuries on UK sites.
Working on rebar mats at height above ground beams and pile caps creates fall risks.
Wire tying using hand tools causes repetitive strain injuries to wrists, hands, and forearms.
Cutting rebar with disc cutters, shears, and benders generates noise, sparks, and sharp off-cuts.
Burns from bar bending machines, cutting torches, and freshly cut steel ends are common injuries.
The Manual Handling Operations Regulations 1992 and Work at Height Regulations 2005 both apply.
Sharp wire ends from tying reinforcement penetrate gloves and cause hand injuries daily.
Steel fixers must hold a valid CSCS card and be competent in the specific fixing methods used.

Impalement risk	Unprotected vertical rebar kills workers who fall onto it — caps must be fitted.
Manual handling	Repetitive heavy lifting of rebar causes chronic back and shoulder injuries.
Fall hazard	Working on rebar mats above voids or at height creates fall and entrapment risks.
Repetitive strain	Wire tying thousands of connections per day damages hands and wrists permanently.

Don't

Fit impalement protection caps to all exposed vertical rebar immediately after placing.
Use mechanical aids — bar benders, lifters, and cranes — for heavy rebar bundles.
Wear cut-resistant gloves to protect against wire ends and sharp bar edges.
Use safe access platforms when fixing rebar at height or above ground beams.
Rotate between tasks — cutting, bending, tying — to reduce repetitive strain.
Wear hearing protection when using disc cutters or rebar cutting equipment.
Maintain good housekeeping — clear off-cuts and tie wire from the work area.
Report any back pain, wrist pain, or hand numbness to your supervisor.
Use battery-powered tying guns to reduce repetitive hand strain where available.
Hold a valid CSCS card and attend the site induction before starting work.

DON'T leave vertical rebar unprotected without impalement caps fitted.
DON'T carry heavy rebar bundles manually when a crane or telehandler is available.
DON'T walk across rebar mats without designated safe walkways in place.
DON'T use bare hands when handling rebar — sharp edges and wire ends cause cuts.
DON'T ignore wrist or hand pain from wire tying — report symptoms early.
DON'T cut rebar without eye protection and hearing protection in place.
DON'T leave off-cuts and tie wire scattered on the work area floor.
DON'T stand below rebar bundles being lifted by crane without an exclusion zone.
DON'T work at height on rebar without fall protection or safe access.
DON'T use damaged bar bending or cutting equipment — report defects immediately.

See also: Reinforcement Fixing Safety | Rebar Impalement Prevention

Generate professional Risk Assessment and Method Statements in minutes. 10 document formats, site-specific content, instant Word download.

Toolbox Talk Record