WAT/Specific/TBT-WAT-011

WwTW Process Tank Safety

Water Safety › Specific › WwTW Process Tank Safety

Presenter		Project
Location		Date

Process tanks at wastewater treatment works include settlement tanks, aeration lanes, and sludge tanks.
These open-topped tanks contain liquid that can be several metres deep with no visible escape route.
Drowning is the primary hazard — falling into an aeration tank is almost always fatal due to reduced buoyancy.
Aerated liquor reduces body buoyancy so significantly that even strong swimmers cannot stay afloat.
Walkways, handrails, and gratings around process tanks must be maintained in good condition at all times.
Rotating equipment such as scrapers, bridges, and aerators create additional entrapment hazards.
H2S and methane can accumulate near tank surfaces, especially during desludging or high-load events.
The Confined Spaces Regulations 1997 may apply where access into drained tanks is required.
Personal flotation devices should be worn when working within two metres of unguarded tank edges.
Rescue equipment including lifebuoys, throw lines, and reaching poles must be available at tank locations.

Drowning prevention	Falling into a process tank, particularly an aerated one, is almost always fatal — prevention is the only effective control.
Toxic gases	H2S and methane near tank surfaces can cause rapid loss of consciousness, leading to falls into the liquid.
Legal duty	CDM 2015 and the Workplace Regulations require safe access and edge protection around all open process tanks.

Don't

Maintain all handrails, guardrails, and edge protection around process tanks
Wear a personal flotation device when working near unguarded tank edges
Check that rescue equipment is present and accessible at each tank location
Isolate and lock off rotating scrapers and bridges before accessing tank areas
Monitor for H2S and methane when working near tank surfaces or ventilation openings
Report any damaged gratings, missing handrails, or defective edge protection
Brief all workers on the specific drowning risks at each process tank
Follow confined space entry procedures for any work inside drained tanks
Ensure someone always knows your location when working near open tanks
Keep walkways around tanks clear of trip hazards, algae, and standing water

DON'T lean over or reach beyond tank edge protection for any reason
DON'T remove or climb over guardrails to access equipment in tanks
DON'T enter the area around aeration tanks without a personal flotation device
DON'T attempt to rescue someone from a tank without trained assistance and equipment
DON'T walk on tank covers or gratings that have not been inspected and rated
DON'T work alone at unguarded process tank locations on the treatment works
DON'T ignore damaged or missing edge protection — report it immediately
DON'T enter a drained process tank without a confined space permit and rescue plan
DON'T operate rotating plant or scrapers while people are on the tank walkway
DON'T assume shallow-looking liquid in tanks is safe — depths can be deceiving

See also: Drowning Prevention and Water Safety | Working Over Water

Generate professional Risk Assessment and Method Statements in minutes. 10 document formats, site-specific content, instant Word download.

Toolbox Talk Record